Bently Nevada 107770-03-01 Velocity Transducer Housing – CENELEC Certified

Bently Nevada 107770-03-01 Velocity Transducer Housing

The Bently Nevada 107770-03-01 is a durable velocity transducer housing approved for CENELEC Zone 1 applications.
It integrates a 330500 Velomitor Sensor with a 21128 stainless housing—factory preinstalled for easy setup and reliable vibration protection.

Quick Product Highlights

• Model: 107770 – Velocity Transducer Housing – CENELEC approved
• Part Number: 107770-03-01
• Mounting Thread: 03 = 1/2-14 NPT
• Cable Exit Fitting: 01 = 1/2-14 NPT plug
• Condition: New & Factory Original
• Warranty: 12 months standard factory warranty

Technical Performance

• Material: 303 Stainless Steel, corrosion-resistant
• Protection Class: IP65 / NEMA 4X
• Frequency Response: 1 Hz – 8 kHz typical
• Output Sensitivity: 3.94 mV/mm/s (nominal)
• Dynamic Range: ±25 g
• Temperature Range: −45 °C to +125 °C
• Shock Resistance: 5000 g peak
• Compliance: RoHS Directive 2011/65/EU
• Certification: ATEX / IECEx for hazardous environments

Special Features

• Explosion-proof and vibration-resistant for Zone 1 & 2 areas.
• Factory-sealed for maximum reliability and leak protection.
• Compact design suitable for tight spaces and retrofit projects.
• Pre-assembled Velomitor sensor saves on installation time.
• Stainless build ensures long-term stability and corrosion protection.

Environmental & Safety Ratings

• Zone 0/1: Must connect only to certified equipment per entity parameters.
• Zone 2: Electrical parameters must not exceed rated limits.
• Cable Type: EN 60079-25 compliant Type A or B cable.
• Hazard Group: Group IIC gas environments.

Shipping & Service

• Global delivery via FedEx, UPS, or DHL.
• Each unit shipped in shock-proof factory packaging.
• Comes with calibration data and installation guide.
• Free technical support during warranty period.

Why Choose Powergear X

• Certified industrial automation parts distributor.
• All products 100% original and tested before shipment.
• Fast worldwide logistics and after-sales support.

FAQ – Expert Insights

• Can this housing be used with third-party sensors?
  Yes, if electrical and mechanical specs match Bently Nevada parameters.
• Is grounding necessary for safe operation?
  Always ground the housing to avoid electrical interference in hazardous zones.
• How do I maintain signal accuracy?
  Use short, shielded cables and avoid routing near high-voltage lines.
• What maintenance is required?
  Inspect seals every 6 months and clean with non-corrosive solvents only.
• Can I replace the Velomitor sensor inside?
  Yes, but it should be done by qualified personnel to keep CENELEC compliance.

Contact & Support

• Email: sales@powergearx.com
• WhatsApp: +86 18030005825
• Please mention Model 107770-03-01 in your inquiry.

Original Source: https://www.powergearx.com/

Copyright © 2026 Powergear X Automation Limited. All rights reserved.